Rigol DS2000 series¶


Status	supported
Source code	rigol-ds
Channels	2
Samplerate	2GSa/s (1ch), 1GSa/s (2ch)
Analog bandwidth	70-200MHz (depending on model)
Vertical resolution	8bits
Triggers	edge, pulse, runt, windows, nth edge, slope, video, pattern, delay, timeout, duration, setup/hold, RS232/UART, I²C, SPI, CAN, USB
Input impedance	1MΩ‖16pF 300V RMS CAT I
Memory	56Mpts (mode/ch-dependent)
Display	8" 800x480, 160K colors
Connectivity	USB host/device, ethernet (LXI), trigger out, pass/fail out
Features	math: +, —, x, /, FFT, vertical sensitivity: 500µV/div - 10V/div
Website	rigolna.com

The Rigol DS2000 Series are 2-channel oscilloscopes with an analog bandwidth of 70-200MHz and 2GS/s sampling rate.

Except for small software differences all models in the series are identical.

There exist two versions of the hardware, version 1 and version 2. Version 2 has a redesigned PCB which is prepared for additional modules, a signal generator and apparently a logic analyzer. Additionally version 2 hardware has the hardware fitted to switch the input impedance to 50 ohms. This is only accessible through SCPI commands, the option in the menu is disabled (as of firmware version 01.01.00.02).

Devices¶

Model	Bandwidth
DS2072	70MHz
DS2102	100MHz
DS2202	200MHz

Protocol¶

The device uses USBTMC or LXI via its ethernet port for communication with a host PC. The protocol is based on SCPI commands.

Resources¶

Photos¶

Rigol Ds2072 Mugshot